Wood Fence Installation in Allen, TX

The reasons vary from house to house. One family wants to sit on the back patio without feeling watched. Another wants the property line between two lots finally defined, or a play space and garden closed in for kids and pets. Sometimes the existing fence has worn out along so many sections that patching would never really catch up.

New fencing is also a chance to fix what never worked: a gate in an awkward spot, a side yard left outside the enclosure, or a fence and gate that don't match. If you want the broader picture of how we handle new projects, see our fence installation page. Here we stay focused on wood fencing for Allen yards.

For backyard privacy, cedar comes up in a lot of Allen conversations. Boards can be set close together for a solid screen, and the natural grain sits comfortably next to turf, shrubs, and flower beds. Layout plays a part too: the fence may step around a mature tree, hug a planting bed, or turn a corner to screen a seating area.

North Texas sun, summer heat, and spring storms all weather wood over time, so some upkeep is part of owning a cedar fence. Many owners stain or seal periodically and keep irrigation and mulch off the lowest boards. The right board style and build approach depend on the specific fence and yard, and we'll walk through those choices with you rather than applying one method everywhere.

A single residential fence often covers several jobs at once. The rear line may mark the boundary with the neighbor behind you, the side runs may close off a narrow passage between houses, and a section near the outdoor living area may need to screen a little more than the rest.

Where the fence meets a walkway, a pedestrian gate has to sit naturally in the line. Toward the front, the fence may stop short of the driveway or finish at a wider opening. Laying out those transitions together keeps the enclosure looking intentional.

The details change with each property, but a typical project follows these steps:

1. Review the property and how the yard is laid out.
2. Discuss your privacy goals and how you need to move through the yard.
3. Note where existing fence sections and gates stand.
4. Plan the fence line and the openings along it.
5. Prepare the areas where the fence will be installed.
6. Install posts, rails, and boards appropriate to the design.
7. Review alignment and confirm every opening works as planned.

Privacy needs are rarely even across a whole yard. A two-story home next door, a lot that backs onto a walking path, or a patio near the rear line may call for full screening in one area while another stretch can stay simpler. Established landscaping can add cover, though roots and beds may also limit where posts can sit.

The fence still needs to be practical. That can mean leaving the side yard easy to reach, tying into an existing fence without an awkward seam, finishing neatly against brick or stone where the house has masonry, and placing gates along the paths people really use.

Openings decide how the yard works once it's fenced. We look at walk gates near the house, side-yard gates wide enough for bins and mowers, the route from the driveway, access for service visits, and clearance around beds and trees. If you think you may want a wider gate later, planning for it now can avoid reworking the fence.

Our gate installation page covers walk and yard gates, and our driveway gates page covers vehicle entrances.

Replacement may deserve a look when deterioration is widespread, several posts are unstable, long runs lean, or large sections are damaged. Changing privacy or layout needs can point the same way. If the trouble is confined to a few spots, our fence repair service is the better starting point.

Installation may fit when there's no usable fence, much of the structure has deteriorated, the layout is changing, or you want new privacy coverage.

Repair may fit when damage is localized, only individual boards or posts are affected, and most of the fence remains serviceable.

See fence installation and fence repair to compare the two.

Allen lots vary more than they might seem from the street. Some have mature trees along the back, some have tight side yards between homes, and many already have fencing on one or more sides that a new fence needs to join. Brick columns or masonry walls may set where a run begins or ends.

Side-yard access and gate openings often drive the final layout. If you live in an HOA community, or City of Allen requirements may apply to your lot, please confirm them yourself before the design is set. We build to the requirements you provide.